General - Siemens SINAMICS G130 Operating Instructions Manual

General

Description
Line reactors limit low-frequency line-side harmonics to permissible values.
NOTICE
Maintain ventilation clearances
The 100 mm cooling clearances above and to the side of the components must be
observed.
Note
Cable lengths
The connecting cables to the Power Module must be kept as short as possible.
NOTICE
Use only approved line reactors
When using line reactors that have not been approved by SIEMENS for SINAMICS, the
following can occur:
 The Power Modules could be damaged/destroyed.
 Line harmonics may interfere with or damage other loads connected to the same line
Hot surfaces
The surface temperature of the line reactors may exceed 80 °C.
NOTICE
Component cooling
Provisions for component cooling must be made at the installation site. Power loss data is
given in the technical specifications.
Line reactors
Operating Instructions, 03/2013, A5E00331462A
supply.
CAUTION
2
7