Logiq E9 Does Not Power On / Boot Up; Power On / Boot Up Flowchart; 5180483-100, Rev; Troubleshooting Trees - GE LOGIQ E9 Service Manual

D 5180483-100, R
IRECTION
7-8-2

LOGIQ E9 Does Not Power On / Boot Up

.
Perform Network Troubleshooting
If the System is not booting and the BIOS screen does not appear, try resetting the BIOS using the
jumper on the motherboard. The jumper is located just below the Battery (Silver disk) in the upper-left
corner of the BEP Motherboard.
If the BEP has been replaced and just turned on for the first time, and no video is co ming out of the main
monitor, open the BEP and ensure that the Video Card is seated properly. Although the packaging is
made to resist several drops, packaging being mishandled in transportation may result in unseated
boards.
7 - 178
PROPRIETARY TO GE
. 7
EV
Figure 7-145 Power On / Boot Up Flowchart - Page 1
System does not boot
Is the AC power cable
seated to the Scanner and
to the wall power outlet?
YES
Is the main breaker
turned ON in the
back of the system?
YES
Has the ON/OFF
key on the Control Panel
been pressed once?
YES
Section 7-8 - Troubleshooting Trees
LOGIQ E9 P
ROPRIETARY
NO
Connect the AC power cable
between the Scanner and the wall
power outlet in right way.
NO
Turn ON the main breaker of
the Scanner.
NO
Press the ON/OFF button on the
Control Panel.
S M
ERVICE ANUAL