Connections On The I/O Rear Panel; Connect Ethernet - GE LOGIQ E9 Service Manual

D 5180483-100, R
IRECTION
3-6-5

Connections on the I/O Rear Panel

NOTE: Accessory equipment connected to the analog and digital interfaces must be certified according
to the respective IEC standards (e.g. IEC60950 for data processing equipment and IEC60601-
1 for medical equipment). Furthermore, all complete configurations shall comply with the valid
version of the system standard IEC60601-1-1. Everybody who connects additional equipment
to the signal input part or signal output part of LOGIQ E9, configures a medical system, and is
therefore responsible that the system complies with the requirements of the valid version of
IEC60601-1-1. If in doubt, consult the technical service department or your local representative
for GE.
3-6-5-1

Connect Ethernet

Connect the Ethernet cable to the Ethernet connector (3) on the External I/O (rear side of LOGIQ E9).
Figure 3-13 Ethernet, Audio (1) and DVI-I (2) connection for External Monitor on
rear side of LOGIQ E9 - R3.x and earlier
3 - 20
PROPRIETARY TO GE
. 7
EV
L R
1 2
Section 3-6 - Completing the setup
LOGIQ E9 P
ROPRIETARY
!
5180173 revx
3
S M
ERVICE ANUAL