Connect Ac (Mains) Power To The Logiq E9; The Circuit Breaker And On/Off Button - GE LOGIQ E9 Service Manual

D 5180483-100, R
IRECTION
3-6-8-3

Connect AC (mains) Power to the LOGIQ E9

Connecting AC Power to the LOGIQ E9 ultrasound unit involves preliminary checks of the power cord,
voltage level and compliance with electrical safety requirements.
NOTE: The LOGIQ E9 will function on Voltages from 100-240 Volts and 50 or 60 Hz. However, if using
220 volt power, then a center tapped power source is required (North America Only).
1.) Ensure that the wall outlet is of appropriate type, and that the Circuit Breaker is turned off.
2.) Uncoil the power cable, allowing sufficient slack so that the unit can be moved slightly.
3.) Verify that the power cable is without any visible scratches or any sign of damage.
4.) Verify that the on-site mains voltage is within the limits indicated on the rating label near the Circuit
Breaker on the rear of the unit.
5.) Connect the Power Cable's female plug to the Power Inlet at the rear of the unit.
6.) Lock the plug in position with the Retaining Clamp (ACC Clamp).
7.) Verify that the Mains Power Circuit Breaker is in OFF position, if not, switch it OFF.
Figure 3-17 The Circuit Breaker and ON/OFF button
8.) Connect the Power Cable's other end (male plug) to a hospital grade mains power outlet with the
proper rated voltage, and the unit is ready for Power ON/Boot Up.
PROPRIETARY TO GE
. 7
EV
Chapter 3 LOGIQ E9 Setup
LOGIQ E9 P
ROPRIETARY
S M
ERVICE ANUAL
3 - 25