Properties - GE LOGIQ E9 Service Manual

D 5180483-100, R
IRECTION
3-9-4-2

Properties

Maximum Retries, Retry Interval, and Timeout are used by the Retry protocol when the LOGIQ E9
encounters communication problems with a service:
Table 3-11
Maximum Retries, Retry Interval, Timeout
Timeout
Maximum Retries
Retry Interval
Using the values in
are the default and recommended settings), the LOGIQ E9 will attempt to establish communications
for 30 seconds, up to three times (the original attempt and two retries), with a gap between each
attempt of 10 seconds.
R3.x and earlier
Allow Multiframe
R4.x and later
Allow Clips
3 - 46
PROPRIETARY TO GE
. 7
EV
Properties
How many seconds the LOGIQ E9 should attempt to establish
communications with the service
How many times to attempt to establish communication again in the event
of failure
How many seconds to wait between each retry attempt
Table 3-10 "Initial Steps - Setup an Image Storage Service" on page 3-44
When a print button is set to RawDicom Single (see:
3-62), and the user presses it while scanning live, it stores a single
page
DICOM frame (bitmap of the image), along with the raw-data of the image.
The raw data allows the system to treat this as a multi-frame image (cine
clip) because it can regenerate the multiple frames from the raw data
when the situation calls for it.
One such situation is "Allow Multiframe." It instructs the LOGIQ E9 to
generate a multi-frame image to send to the service in the event that the
clip was stored via a print button set to RawDicom Single. When the time
comes to send the clip to the service, the LOGIQ E9 will generate a multi-
frame from the raw data before putting it on the spooler. Such multi-frames
are not permanently stored on the LOGIQ E9 local hard drive.
NOTE: "Allow Multiframe" is relevant only for clips stored via a print button
set to RawDicom Single. Images stored with either "Dicom & Multiple" or
"RawDicom & Multiple" print button settings are always transferred as
multi-frame images, regardless of the setting for "Allow Multiframe."
Loops shall be transferred only if this option is checked. Default state
should be checked.
Section 3-9 - Connectivity Setup and Tips
LOGIQ E9 P
(continued on next page)
S M
ROPRIETARY ERVICE ANUAL
(which
2.) "Print Button" on