Setting The Handwheel Scale - Dürkopp Adler 567 CLASSIC Service Manual

Setting the handwheel scale

4
Checking the correct setting
1. Lock the machine in place at position 2 ( page 16).
 The handwheel is at position 0°.
Fig. 12: Setting the handwheel scale
Setting steps
The handwheel is fastened using two setscrews, which you can see
through the screw opening (1).
1. Turn handwheel until the first setscrew is under the opening (1)
2. Release the setscrew through the opening (1).
3. Turn the handwheel by 50° such that the second setscrew is under the
4. Release the setscrew through the opening (1).
5. Lock the machine in place at position 2 ( page 16).
6. Turn the handwheel scale so that the 0° is at the center of the marking (2).
7. Tighten the setscrew through the opening (1).
8. Remove the lock ( page 17).
9. Put the handwheel into the 50° position.
10.Tighten the setscrew through the opening (1).
Service manual 567 classic - 01.0 - 10/2015
Setting the handwheel scale
WARNING
Risk of injury.
Crushing injuries from moving parts.
Switch the sewing machine off before you check
and set the position of the handwheel on the arm
shaft.
If a different degree number is next to the marking (2) then you will
have to reset the graduated scale.
(1) - Screw opening
opening (1)
(2) - Marking
19