Table of Contents
Advertisement
Working basis
Fig. 10: Locking the sewing machine in place
Locking the machine in place
1. Remove the plug from the locking opening (2).
2. Turn the handwheel until the appropriate groove (1) is in front of the lock-
3. Insert the locking peg (3) with the appropriate end in the groove (1).
Removing the locking mechanism
1. Pull the locking peg (3) out of the groove (1).
2. Insert the plug into the locking opening (2).
3.6 Putting the handwheel into position
With some settings, the graduated scale on the handwheel has to be put
into a certain position.
Fig. 11: Putting the handwheel into position
Setting steps
1. Turn the handwheel until the specified number on the graduated
Service manual 567 classic - 01.0 - 10/2015
①
②
(1) - Groove
(2) - Locking opening
ing opening (2):
• Small groove at handwheel position 0°
• Large groove at handwheel position 200 – 205°
①
②
(1) - Graduated
(2) - Marking
scale
scale (1) is next to the marking (2).
③
(3) - Locking peg
17
Advertisement
Table of Contents
