Setting The Needle Bar Height - Dürkopp Adler 567 CLASSIC Service Manual

Position of the hook and needle
Fig. 30: Adjusting the needle guard
Setting steps
1. Turn the handwheel and check how far the needle guard (2) pushes the
2. Turn the screw (1) such that the needle guard (2) just pushes the

11.4 Setting the needle bar height

Order
First check the following settings:
• Loop stroke position ( 11.2 Setting the loop stroke position,
• A straight and undamaged needle must be inserted
Correct setting
Machine locked in place in position 1 ( page 16) and stitch length ad-
justing wheel set to 0.
 The hook tip is level with the lower third of the groove for the needle.
Service manual 567 classic - 01.0 - 10/2015
①
②
(1) - Screw
(2) - Needle guard
needle away.
needle (3) far away enough so that it cannot be touched by the hook tip:
• For pushing away more: Turn it counterclockwise
• For pushing away less: Turn it clockwise
WARNING
Risk of injury.
Risk of crushing injuries and stab wounds from mov-
ing and sharp parts.
Switch off the sewing machine before checking and
setting the needle bar height.
page 38)
( Operating manual section, Inserting and replacing the needle)
③
(3) - Needle
41