Reset To Factory Settings; Check The Machine Type Setting; Setting The Machine Type - EWM WEGA 401 Operating Instructions Manual

5.1.3.7

Reset to factory settings

All user settings will be overwritten with factory settings and must therefore be checked
afterwards, or set up again!
After resetting the machine control to the factory settings, it is essential that the machine
type used is checked and reset if necessary.
Operating
element
+
5.1.3.8

Check the machine type setting

When first switching on after resetting to the factory settings, the machine type is
displayed under the designation "tyP".
If an incorrect machine type is shown, it must be reset.
„tyP 00"
„tyP 01"
„tyP 02"
„tyP d02"
„tyP d03"
„tyP d04"
5.1.3.9

Setting the machine type

Operating
element
+
Item No.: 099-004934-EWM01
Action Result
Switch off the welding machine.
1 x
Press and hold both buttons.
Switch on the welding machine, "rES" is shown briefly on the display.
1 x
SATURN 251
SATURN 301
SATURN 351
WEGA 351, SATURN 351 DG
WEGA 401,451
WEGA 501,601
Action Result
Switch off the welding machine.
1 x
Press and hold both buttons.
+
Switch on the welding machine, "Anl" is shown on the display.
1 x
Whilst "Anl" is being displayed, set the machine type:
0 - SATURN 251
1 - SATURN 301
Functional characteristics
Machine control – Operating elements
NOTE
NOTE
2 - SATURN 351
3 - WEGA (all)
43