Avaya 1692 IP Conference Phone
NOTE: Options are 0-4095. Both 0 and 4095 are restricted to data VLAN
NOTE: This is the value for VLAN tagging packets being sent by the phone and
packets to be accepted by the phone.
10.
Enter the VLAN Test (Not used when phone is statically configured).
Default is 60.
Options are 0-999
VLAN Test is the number of seconds during which the phone will make requests for
an IP Address from a DHCP server with the configured VLAN ID (assuming non zero
is value configured).
•
•
11.
Enter the 802.1X Configuration.
Options are ON, OFF. Default is OFF.
If 802.1X enabled on the switch then On may be used to enable wired line
authentication.
If On is specified, then the following screens will appear to set the username and
password for EAP.
a. EAP User Name default is the MAC address of the phone.
Issue 1, September 2010
If 802.1Q is Auto and VLAN ID is set to a non-zero value and the phone does not
receive a response during the VLAN Test period then it will start requesting for IP
address in other network VLANs.
If 802.1Q is On and VLAN ID is set to a non-zero value and the phone does not
receive a response during the VLAN Test period then it will start requesting for IP
address with VLAN = 0 tagging.
Installation, Configuration and Software Upgrade Guide
17