Appendix; Care; Contact With Liquid; Questions And Answers - Swisscom Top S324 ISDN User Manual

Gigaset SX100isdn / englisch / A31008-X150-B102-1-7619 / appendix.fm / 13.10.2003

Appendix

Appendix

Care

Wipe the base and handset with a damp cloth (use no solvent) or an antistatic cloth.
Never use a dry cloth. This can cause static.

Contact with liquid

If the handset should come into contact with liquid, on no account switch the device
on. Remove all batteries immediately.
Allow the liquid to drain out of the device, and then pat all parts of the device dry.
Keep the handset with the batteries removed in a warm, dry place for at least 72 hours.
In many cases, you will then be able to use it again.

Questions and Answers

If you have any questions about the use of your phone, you can contact us 24/7 at
www.my-siemens.com/customercare. You will find the most frequently asked
questions and answers below.
What has happened
when ...
... the display is blank?
... the handset fails to respond
to a key press?
... "Base x" or Base Search
flashes in the display?
... the handset does not ring? The ringer is switched off.
... the phone number of the
caller is not displayed even
though CLIP is set?
... the handset does not ring
after setting up the ISDN
phone number (MSN)?
... You don't hear anything?
94
!
Possible cause
The handset is not switched on.
The batteries are flat.
The keypad lock is activated.
The handset is outside the range
of the base.
The handset is not registered.
The base is not switched on.
Internal call forwarding is set to 0
rings (= immediate call
forwarding).
Night service is active.
Calling line identification is
blocked.
Area prefix (town/city code) was
saved with the MSN.
u
The key was pressed – the
microphone has been muted.
Possible solution
Hold down the End call key
a
for about 2 seconds.
Charge or replace the batteries
(page 9).
R
Press the hash key
around 2 sec. to deactivate
the lock (page 11).
Move the handset nearer to the
base.
Register the handset (see
page 9 and see page 81).
Check the power connector at
the base (page 8).
Activate the ringer of the
handset (page 87).
Increase the number of rings
for the internal call forwarding
(page 70).
Deactivate Night service
(page 58).
The caller must ask his network
provider to enable the
transmission of his number
(CLI).
Save the MSN without the
area prefix (page 65).
Press to return to the call.
for