Swisscom Top S324 ISDN User Manual page 72

Gigaset SX100isdn / englisch / A31008-X150-B102-1-7619 / settings_bs.fm / 13.10.2003
Setting the system
Activating/deactivating internal call forwarding
Prerequisite: Internal call forwarding can only be activated if the forward destination is
set up.
v
s
Base Settings
s
Int. call forw.
~
OK
either ...
Activate?
or ...
Deactivate?
Defining the number of rings
When ring delay is used, the number of rings before the call is forwarded must be
defined. Between 0 (= immediate call forwarding) and 9 rings can be set. There are
5 seconds between rings.
The factory default setting is 0 rings (= immediate call forwarding).
v
s
Base Settings
s
Forward. base
~
OK
s
No. of rings
~
OK
a
Forwarding external calls – CF (Call Forwarding)
For each incoming MSN, you can save a 'call to' number for each of the three following
conditions:
–
Immediately
If call forwarding is sent to the base station (internal) (page 73), the
◆
condition
i
The three conditions can be activated simultaneously.
◆
If Night service was set up for an incoming MSN (page 58), external
◆
call forwarding cannot be set up or changed for this incoming MSN.
All executed external call forwarding is entered in a list. Active call forwarding is marked
in this list.
By factory default, external call forwarding is not activated.
70
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Enter system PIN, if needed (page 61).
Activate:
Confirm.
OK
Deactivate:
Select the menu item and confirm.
OK
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Enter system PIN, if needed (page 61).
Select the menu item and confirm.
OK
Enter the number of rings and confirm.
Hold down (return to idle status).
–
On busy On no reply
is not available.
On busy