Swisscom Top S324 ISDN User Manual page 12

Gigaset SX100isdn / englisch / A31008-X150-B102-1-7619 / starting.fm / 13.10.2003
Preparing to use your phone
Registering the handset and charging the batteries
When you place the handset into the base, it automatically registers. This can be done
as follows:
1. Place the handset turned off in the base with the display up.
2. Wait till the handset has automatically registered with the base (page 81): This takes
about one minute. You will now see "Time not activated" in the display. The
handset is assigned the internal number 11 (the first valid internal number for
handsets) and the internal name Internal 11 appears in the display. You can change
the handset name (page 64).
If automatic registration is interrupted, you must register the handset manually as
described starting on page 81. There is a table of the most important questions and
answers to help you (page 94).
Now leave the handset in the base for the batteries to charge – the batteries are supplied
uncharged. The charging is indicated in the upper right of the display where the
U
charging status
e
The batteries are (almost) flat
V
Batteries
i
If you want to register further handsets, please turn to page 81.
Note
Your telephone is now ready for use. To correctly record the time of calls you must now
set the date and time. Depending on the network provider, the date and time are
updated automatically by the telephone network with every outgoing call. All the
settings necessary for operating the telephone can be set up easily with the Getting
started wizard (page 14).
Attaching the belt clip
Push the belt clip onto the back of the handset until the lugs click into the recesses on
either side of the handset.
10
flashes:
1
/ charged
3
U
2
Batteries / charged
3
¤
Batt. fully charged