Swisscom Top S324 ISDN User Manual page 17

Gigaset SX100isdn / englisch / A31008-X150-B102-1-7619 / starting.fm / 13.10.2003
Examples for assigning MSNs:
You have ordered four MSNs, two for business use (MSN1, MSN2) and two for private
use (MSN3, MSN4). Four handsets are connected to one base. Two handsets (Int.11 and
12) are for business use, two handsets (Int.13 and 14) are for private use.
Internal parties
Handsets
Handset
Handset
The following applies to Comfort handsets:
Because internal 11 and internal 12 handsets are assigned two (receiving) MSNs each,
they can use the MSN next call performance feature (page 75). They can change to
(sending) MSN2 during each outgoing external call. The internal 13 and 14 handsets
cannot do this.
Ring delay
When ring delay is active, the signal for an incoming call is delayed on the handset (e. g.
after 5 rings – the number can be set). Ring delay can be set individually for each
handset and for each incoming MSN (page 66).
As an example, an incoming call should be signalled to MSN1 Int.11 when Int.12 does
not answer the call. To do this, activate the ring delay for Int.11 and MSN1 (e.g., to
5 rings). The call is signalled directly to Int.12 , but Int.11 is signalled after the 5th ring.
Launching the Getting started wizard and setting the basic
Launching the Getting started wizard:
v
s
Base Settings
s
Installation
[RRRRRRRRRRRRRRRRRRRRRRRRRR]
YES
~
OK
◆
◆
i
◆
◆
Usage
Int.11 , 12 Business
Int.13 Private
Int.14
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Press the display key to launch the Getting started
wizard.
If you already have set a system PIN (not 0000)
(page 61), you will be asked to enter it.
If required, enter the system PIN and confirm.
The Getting started wizard cannot be used simultaneously by multiple
handsets.
If there is already settings data (factory default or previous settings),
this data is shown at the appropriate positions in the display and can
be modified there.
To cancel the Getting started wizard, press the end call key and hold.
All changes you have already saved using Save entry
retained. The handset returns to idle status.
To skip a setting, press the display key
Preparing to use your phone
Incoming MSN Outgoing MSN
MSN1 MSN2
, MSN1
MSN3 MSN3
MSN4 MSN4
.
§§NO§§
are
§§OK§§
15