Troubleshooting - Philips WP3893 User Manual

regards certifying working of the Pure Water
Dispenser.
8 Guarantee will cease/will not be valid
anymore if the Pure Water Dispenser is used
for commercial purposes.

10 Troubleshooting

Problem
Filter LED blinking
Filter LED constant
Battery LED blinking red
Battery LED blinking green
Water LED glows constantly
Water dripping from the appliance Pipe may not be connected properly. Check all the connections. Contact
UV LED ON
Not dispensing water even if error
indications are off
All the LED indicators do not flash
on Power ON (as per regular
behaviour)
18
Cause
Filter not working optimum. End
stage.
Filter need replacement.
Battery at its critical stage, needs
charging.
Battery is being charged.
Water is not available.
AN error in the UV chamber.
No power (In case of Models without
battery).
Filter is not mounted properly.
Non Philips filter mounted.
Fuse blown up due voltage fluctations. Contact your dealer or a Philips
Filter expiry before its stipulated
3000 litres.
LED damaged.
Solution
Buy new filter for later replacement
For replacement of filter, see chapter
8.
Switch on the AC supply.
Check water availability with
appropriate pressure (0.5 - 2 bar).
your dealer or a Philips service
centre.
Check if UV cover is closed. Clean
quartz tube (see section 7.0.5). If
problem persists, contact your dealer
or a Philips service centre.
Check if mains power supply is
available and the power cord is
correctly connected.
Mount filter properly.
Always buy original Philips filter.
service centre.
Contact your dealer or a Philips
service centre.
Contact your dealer or a Philips
service centre.