Getting Started - Philips WP3893 User Manual

3 Certifications
•
This Philips Pure Water Dispenser conforms
to the highest standards for contaminant
reduction, structural integrity and material
safety and thus ensures that you get Pure
Water Made Easy - Always. The following
certifications are a proof of that.
3.0.1 WQA Gold Seal Certified:
•
WQA (Water Quality Association, UsA)
only awards the gold seal to those systems,
components, or additives that have met or
exceeded industry standards for contaminant
reduction, structural integrity, and material
safety.
•
This product is certified by WQA to conform
to NsF/ANsI 42 for the removal of chlorine
and particulates (removes all classes of
particulates from Class I till Class VI - particle
size 0.5µm till 80 µm), NSF/ANSI 53 for the
removal of turbidity, volatile organic chemicals
(VOC's) and cysts and NSF/ANSI 55 Class A
for microbiological dis-infection. Both the
product and the filter are Gold seal certified
by WQA.
3.0.2 Tested by Kiwa Water Research:
• Microbiological performance tested by Kiwa
Water Research (The Netherlands) according
to the NSF standard 55, Class A protocol
(2004).
6
4 Getting Started
4.0.1 Installation
• Make sure the routing of the pipe and wire to
the socket are proper.
•
In case the water pressure in your area is
lower than the minimum specified (0.5 bar),
we recommend the use of a suitable domestic
water pump.
•
If the pressure is higher than the maximum
specified (2.0 bar), use of the pressure
reducing valve is required.
Note:
D
It is recommended that the Pure Water
Dispenser be installed by Trained Service
Technicians.
•
Always install the Pure Water Dispenser in a
vertical position. Do not install it inclined or
horizontally.
•
Do not connect to an electrical point placed
below the Pure Water Dispenser.
• Drill 3 holes on the wall as shown in picture.
150mm 150mm
192.5mm 192.5mm
•
Distance of the Pure Water Dispenser should
be 1m from the tap.
1m