Clean the quartz tube with clean moist cloth
4
and dry it completely.
Insert the rubber O-ring to the depth of 2-3
5
mm from the open end.
Insert the tube with the rubber o-ring in the
6
chamber.
Put the UV Lamp assembly back into place
7
(with the lamp support & wires).
Fix the UV Lamp retaining cap.
8
Fix the wire connectors back.
9
Close the UV access cover.
1 0
7.0.6 Supply of consumable treatment
components
For filter assembly (WP3990) and UV lamp
assembly (12NC - 421530875020) contact
Domestic Appliances and Personal Care Products
(see chapter guarantee & service).
16
8 Disposal
•
Do not throw away the appliance with the
normal household waste at the end of its life,
but hand it in at an official collection point for
recycling. By doing this, you help to preserve
the environment.
•
The built-in rechargeable batteries contain
substances that may pollute the environment.
Always remove the batteries before you
discard and hand in the appliance at an official
collection point. Dispose of the batteries at
an official collection point for batteries. If you
have trouble removing the batteries, you can
also take the appliance to a Philips service
centre. The staff of this centre will remove the
batteries for you and will dispose of them in
an environmentally safe way.
8.0.1 Disposal of the batteries
Remove the battery from the Pure Water
Dispenser before you discard the Pure Water
Dispenser after end of life
Open the door of the Pure Water Dispenser.
1
Use a crosshead screwdriver to remove the
2
three screws on the component cover.