Philips WP3893 User Manual page 11

•
After 10 minutes, the device goes into
(Waiting for Water) stand-by mode
• Make sure that you place a container
of appropriate capacity below the Pure
Water Dispenser to collect the dispensed
water
•
When water supply resumes, the Pure
Water Dispenser dispenses the pre-
selected quantity and stops automatically
•
After 10 minutes, the Pure Water
Dispenser goes into stand-by mode
Note:
D
• In (Waiting for Water) Stand-by mode, all
the LED's & the LCD would switch off,
except for the power 3, battery z the
Water LED (Flashing).
• After dispensing water, the preset quantity
remains on screen.
6.0.4 Battery (only for WP 3893)
Battery Charging
1
•
To charge the battery, switch on the mains
power supply.
• switch on the Power button to start
charging the battery.
•
During charging the Battery lED z
would flash green.
•
Once the battery is fully charged, the
Battery lED z would glow constant
green.
•
Charge the battery for 14 hours before
first use. Subsequently battery charging
time will be 12 hours for a full recharge.
Note:
D
The Pure Water Dispenser will switch to
Standby (Power Saving) mode after 10 minutes
but the battery will continue to charge.
Remarks: lead acid gel batteries lose their life
when not charged regularly. The performance and
functionality of the battery is dependent directly
on the charging pattern. We recommend that the
battery is charged regularly till it gets fully charged.
6.1 Other functions
6.1.1 Pure flush
The Pure flush function needs to be performed in
either of the 3 conditions.
•
1st time use of the Pure Water Dispenser
• If the Pure Water Dispenser is not used for
more than 2 days
•
When the filter is replaced, the Pure Water
Dispenser would perform the Pure Flush
function automatically and flush out 10 litres
of water (see section 7.0.2 Replacement).
Switch on the Pure Water Dispenser.
1
Wait till the Dispense button lED starts
flashing (Ready to dispense - Manual mode).
Press and hold the Dispense button for 4
2
sec
•
The Pure Water Dispenser will start
flushing out water.
• 10 litres of water would be flushed out,
so make sure that you place a container
below the dispenser.
Warning:
B
Do not use this flushed water for drinking.
•
Dispense button lED would glow a constant
green as an indication of Pure Flush in
progress. All the other indications (lEDs)
would be OFF.
Note:
D
To cancel Pure Flush midway, press the Power
Button to switch off the Pure Water Dispenser.
6.1.2 Audio on/off
The Pure Water Dispenser plays an audio while
it's dispensing water. This is just to remind you that
the dispensing is in progress. The factory (Default)
setting for this audio would be "AUDIO OFF". You
can switch the audio ON if required Power on
the Pure Water Dispenser.
Power on the Pure Water Dispenser.
1
11