Water Dispenser - Philips WP3893 User Manual

This Pure Water Dispenser has low electricity
consumption and is rated at a maximum of
30W. To make it even more energy efficient,
the UV lamp switches off when the Pure
Water Dispenser has not been used for 10
minutes.
Smart Display: Smart Display for easy
9
settings and feedback.
The lCD display gives clear, legible feedback
and is easy to use when programming settings.
Audible Indications: Audible reminder lets
1 0
you know when the Pure Water Dispenser is
on.
While the Pure Water Dispenser is dispensing
water, an optional audible reminder will notify
you that the Pure Water Dispenser is on.
6 Using Your Pure
Water Dispenser
Note:
D
• Open the tap connected to the Pure
Water Dispenser.
• Switch on the mains power supply to the
Pure Water Dispenser.
6.0.1 Purifying in Manual Mode: (2 Easy
Steps)
Press the Power button on the Pure Water
1
Dispenser
•
All LED's will flash on and off
•
Power lED 3 will be ON
•
lCD display will be ON
•
Battery lED will glow green, if AC supply
is available Else RED, on battery. If battery
is being charged, it would flash green/
Battery at critical stage – flashing red.
(Only for model WP 3893).
•
The Pure Water Dispenser checks for
water supply
• The Pure Water Dispenser checks the
Filter c
•
The Pure Water Dispenser checks the UV
•
Purification Stage indicator starts glowing
in a sequence – RED, YEllOW, gREEN
(This would take 30 seconds)
• Dispense button d starts flashing (Default
mode= manual)
Press Dispense button
2
•
The Pure Water Dispenser starts
dispensing water. (While dispensing,
the quantity of water dispensed would
be shown on the lCD display & the
Dispense button lED glows a constant
green)
•
Again, press the dispense button d to
stop dispensing water. The dispense
button LED will start flashing again (Ready
to dispense again)
9