Philips WP3893 User Manual page 14

Uv water purifier
Hide thumbs Also See for WP3893:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
Push back the filter unit into its place.
1 0
Close the door.
1 1
Note:
D
Each time that you replace the filter, ensure that
you clean the Micro filter as well (see section
7.0.1 Cleaning).
Once you have replaced the existing filter with a
new one, you need to electronically confirm the
replacement. The Pure Water Dispenser will start
working normally only once you confirm the new
filter.
7.0.3 Filter Replacement Conformation
How to Confirm Filter Replacement?
Switch on the Pure Water Dispenser.
1
If you have replaced the filter during the
warning period the Filter LED would flash.
Wait till the Dispense button lED starts
flashing (Ready to dispense - Manual
mode).
If you have replaced the filter after filter
expiry the Filter lED will be constantly
ON.
Press and hold "Litres" button and the
2
"Dispense" button together for 4 sec.
14
(A) Press and hold the "litres" button.
(B) Press and hold the "Dispense" button.
(C) Make sure that you press and hold
both these buttons together for more
than 4 sec.
The Pure Water Dispenser will now
acknowledge the new filter.
The Filter lED will switch off which means
that the new Filter is registered.
If the Filter warning still persists, try
repeating steps
(A), (B), (C).
Once the new Filter is acknowledged the
Pure Water Dispenser will automatically
flush 10 litres of water.
Make sure that you either drain that water
to the sink or place a container (10 Litres)
to collect the flushed water and discard
it later.
Note:
D
If you have replaced the filter during the
warning period wait until the Dispense
button LED starts flashing (Ready to
dispense - Manual mode) and then follow
steps (A), (B), (C).
If you have replaced the filter after filter
expiry, the Filter LED will glow constantly
after which follow steps (A), (B), (C).
Do not forget to keep a container (10
litres) to collect the flushed water.
7.0.4 Replacing UV Lamp
Note:
D
While replacing the new lamp assembly
please ensure that it is with Philips 12NC
- 421530875020.
Switch off the Pure Water Dispenser
before you commence UV Lamp
replacement.
Remove the UV access cover.
1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wp3892

Table of Contents