Philips WP3893 User Manual page 12

Wait till the Dispense button lED starts
flashing (Ready to dispense state - Manual
mode).
Press the hold "Litres" button.
2
When you Press and hold the "litres" button
for more than 4 sec the "During Dispense"
audio will be turned ON.
To switch the audio OFF, press and hold the
"litres" button again for 4 sec.
Note:
D
• To perform this operation, make sure that
the Pure Water Dispenser is in the Manual
mode, and the Dispense button LED is
flashing (Ready to dispense).
• The Audio ON/OFF setting will change
to default (Factory setting – "AUDIO
OFF") when the Pure Water Dispenser is
powered on next time.
12
7 Maintanance
7.0.1 Cleaning
How to clean your Pure Water Dispenser.
1
•
Clean the Pure Water Dispenser regularly
using a damp (not wet) cloth.
•
Do not pour water over the Pure Water
Dispenser.
•
Do not use corrosive and abrasive
cleaning products.
•
If not used for 2 days: Press & hold the
Dispense button for 4 seconds to flush
out 10 litres of water into a container.
How to clean the Macro filter.
2
•
switch off the Pure Water Dispenser.
•
Turn off the water supply to the Pure
Water Dispenser.
•
Unscrew the cap (and hold it in a vertical
position to avoid any spillage of water).
•
Pull out the macro filter.
•
Rinse it in running water and clean the
dirt on the mesh.
•
After cleaning put the Macro filter back in
the same position.
•
Close the cap.
•
Open the tap and start using the Pure
Water Dispenser.
7.0.2 Replacement
Note:
D
Switch off the Pure Water Dispenser before you
commence filter change.