Philips WP3893 User Manual page 10

Note:
D
• In case water supply shuts off while
dispensing in Manual mode, the Pure Water
Dispenser will switch to Auto mode.
• If you want to program the Pure Water
Dispenser for a later dispense, (when
water supply resumes) select a quantity
by pressing Litres button. The LCD display
will show the selected quantity.
• The Pure Water Dispenser is now
ready to dispense this selected quantity
automatically, once the water supply
resumes.
6.0.2 Purifying in Auto mode: (4 Easy
Steps)
Press the Power button on the Pure Water
1
Dispenser.
• Wait till the Dispense button d starts
flashing
Press the Mode button
2
•
The Pure Water Dispenser goes into
AUTO f mode
•
The Dispense lED switches off, lCD
display starts flashing
Press the Litres button
3
•
Pressing this button would let you select
the quantity of water required
•
A single press of the button increases the
quantity step by step, (0.2 Litres)
•
Press and Hold the button for fast
increment in quantity. Once the quantity is
selected, the Dispense button d will start
flashing
Press the Dispense button
4
•
The Pure Water Dispenser would start
dispensing water
• The lCD display shows a reverse count
as the water is being dispensed. (Pending
quantity would be displayed)
•
The Pure Water Dispenser would
automatically stop once it has dispensed
the selected quantity
10
• The lCD display would retain the
previously selected quantity so that you
can refill multiple containers of the same
quantity.
• To cancel/reset the existing setting, either
press the Mode button (switch to manual
mode) or switch off the power button.
•
To reset quantity, press the litres button
Note:
D
• Incase water supply shuts off while
dispensing in Auto mode, the Pure Water
Dispenser will program itself to dispense
later.
• The LCD display shows pending quantity,
which you can change if required.
• The Pure Water Dispenser is now ready
to dispense the pending/changed quantity
once the water supply resumes.
• Ensure that you place a container of
appropriate capacity to collect the purified
water. To cancel the existing setting, switch
off the Pure Water Dispenser .
6.0.3 Setting the Pure Water Dispenser
when water is not available
Press the Power button on the Pure Water
1
Dispenser
•
When water is not available the Pure
Water Dispenser switches to Auto mode
f.
• Water indicator b will glow RED
•
The LCD display will start flashing
Press Litres button (to select quantity)
2
•
select the quantity of water you need to
dispense when water supply resumes
• Once you select the quantity the
Dispense button starts flashing
Press Dispense button
3
•
The Dispense button lED switches off
• The Water lED b starts flashing which
means that the Pure Water Dispenser has
programmed itself for later dispense when
water supply resumes