Martin MAC Encore Performance CLD User Manual page 35

Short code
Long message and explanation
UPL ERR PAN/TILT
UEPT
Could not upload new pan/tilt system firmware during a firmware upload. Error cleared when
new firmware is uploaded successfully or power is cycled off and on.
UPL ERR Z/F
UEZF
Could not upload new zoom/focus system firmware during a firmware upload. Error cleared
when new firmware is uploaded successfully or power is cycled off and on.
UI TEMP CUT OFF
UITC
User interface (LCD display and control panel) PCB temperature cutoff activated.
UI TEMP SEN ERR
UITE
User interface (LCD display and control panel) PCB temperature sensor error.
VOLT AT NODE LOW
VOLO
Low voltage detected in node PCBA.
TELLOW ERROR
YEER
Yellow flag position error.
ZF TEMP CUT OFF
ZFTC
Zoom/focus effect temperature cutoff activated.
ZF TEMP SEN ERR
ZFTE
Zoom/focus effect temperature sensor error.
ZOOM ERROR
ZOER
Zoom position electrical indexing system timeout.
The fixture reports a calibration error if valid calibration data is not detected in EEPROM. The fixture may be
unable to read/write calibration data to EEPROM.
Table 5: Error messages
Service and display messages 35