Error Messages - Martin MAC Encore Performance CLD User Manual

Short code
SERV
SLW
UITW
ZFTW
*High temperature warnings are canceled as soon as temperature returns to normal. If temperature reaches
cutoff level, the warning is replaced by a cutoff error message.

Error messages

Error messages indicate that a problem is present. The MAC Encore Performance communicates errors as
follows:
• Error messages flash in the display.
• If more than one error is detected, the fixture flashes all errors three times each.
• Errors are shown in the display regardless of display status: they override an inactive display and any
other information that the display might be showing.
• If an error is present, the status LED flashes red.
The possible error messages are listed in Table 5 below
Short code
APER
ARER
BEER
BETC
BETE
C1ER
CECM
CEEF
CELD
CEPT
CEZF
CMTC
CMTE
32
Long message and explanation
SERVICE MODE
Fixture in service mode.
SAFETY LOOP
A safety loop error occurred but is no longer active. Warning message is cleared at the next
power off/on cycle.
UI TEMP HIGH
User interface (LCD display and control panel) PCB sensor detects abnormally high operating
temperature.*
ZF TEMP HIGH
Zoom PCB sensor detects abnormally high operating temperature.*
Table 4: Warning messages
Long message and explanation
AW POS ERROR
Animation wheel position error.
AW ROT ERROR
Animation wheel rotation error.
BEAM SHAPER POS
Beam shaper position error.
BEAM TMP CUT OFF
Beam temperature cutoff activated.
BEAM TMP SEN ERR
Beam temperature sensor error.
COLOR WHEEL 1 ERR
Color wheel position error.
COMM ERR CMY
CMY flags position system communication error.
COMM ERR EFFECT
Effects position system communication error.
COM ERR LED DRV
LED driver communication error.
COM ERR P/T
Pan/tilt driver communication error.
COM ERR Z/F
Zoom/focus driver communication error.
CMY TEMP CUT OFF
CMY module temperature cutoff activated.
CMY TEMP SEN ERR
CMY module temperature sensor error.
Table 5: Error messages
MAC Encore Performance User Guide
: