Martin MAC Encore Performance CLD User Manual page 28

Menu level 1 Menu level 2
EFFECT
SHORTCUT
COOLING MODE
PERSONALITY
(continued)
DISPLAY
ERROR MODE
HIBERNATION
MODE
FACTORY
DEFAULT
CUSTOM 1
DEFAULT
SETTINGS
CUSTOM 2
CUSTOM 3
28
Menu level 3 Menu level 4
ON
OFF
REGULATED FANS
FULL
MEDIUM
LOW
ULTRA-LOW
ON
2 MINUTES
DISPLAY SLEEP
5 MINUTES
10 MINUTES
DISPLAY
10 ... 100
INTENSITY
DISPLAY NORMAL /
ROTATION ROTATE 180
DISPLAY
1 ...100
CONTRAST
NORMAL
SILENT
OFF
ON
ARE YOU SURE?
LOAD
YES/NO
ARE YOU SURE?
LOAD
YES/NO
ARE YOU SURE?
SAVE
YES/NO
ARE YOU SURE?
LOAD
YES/NO
ARE YOU SURE?
SAVE
YES/NO
ARE YOU SURE?
LOAD
YES/NO
ARE YOU SURE?
SAVE
YES/NO
Table 3: Control menus
MAC Encore Performance User Guide
Notes (Default settings in bold print)
Effects take shortest route during
changes, crossing open positions if
necessary
Effects avoid open positions during effects
changes
Fans optimized for light intensity
(temperature controlled by regulating
fan speed, light output unaffected)
Fans set to full/medium/low/ultra-low
constant speed, fixture temperature
controlled by regulating light output.
Display remains permanently on
Display goes into sleep mode 2 minutes
after last key press
Display goes into sleep mode 5 minutes
after last key press
Display goes into sleep mode 10 minutes
after last key press
Set display intensity in % (default = 100)
Display orientation normal or rotated 180°
Adjust display contrast (default = 41)
Enable error messages and warnings in
display
Disable error messages and warnings in
display (status LED will still light to indicate
fixture status if error has been detected or
fixture has a warning)
Disable hibernation mode
Enable hibernation mode (light output and
motor operation set to zero)
Return all settings (except calibrations) to
factory defaults
Load Custom Settings 1
Save fixture's current settings as Custom
Settings 1
Load Custom Settings 2
Save fixture's current settings as Custom
Settings 2
Load Custom Settings 3
Save fixture's current settings as Custom
Settings 3