Control Panel Menus - Martin MAC Encore Performance CLD User Manual

Control panel menus

MAC Encore Performance firmware version 1.0.0.
Menu level 1 Menu level 2
DMX ADDRESS 1 – XXX
FIXTURE ID 0 – 9999
PAN/TILT
SPEED
PERSONALITY
DIMMER CURVE
TUNGSTEN
EMULATOR
ALTERNATE
COLOR TEMP
FOCUS
TRACKING
VIDEO
TRACKING
DMX RESET
Menu level 3 Menu level 4
User-settable fixture ID number
PAN INVERT ON/OFF
TILT INVERT ON/OFF
FOLLOWSPOT
ON/OFF
MODE
LIMIT ENABLE ->
ON/OFF
PAN MIN ->
degrees
PAN MAX ->
LIMIT PAN/TILT
degrees
TILT MIN ->
degrees
TILT MAX ->
degrees
FAST
PAN/TILT
SMOOTH
FOLLOW P/T
EFFECT
FAST
SLOW
LINEAR
SQUARE LAW
INV SQ LAW
S-CURVE
ON/OFF
ON/OFF
ENABLED
DISABLED
ENABLED
DISABLED
ON
OFF
Table 3: Control menus
Control panel menus
Notes (Default settings in bold print)
DMX address (default address = 1). The
DMX address range is limited so that the
fixture will always have enough DMX
channels within the 512 available.
0
Inverse DMX pan control: right → left
Inverse DMX tilt control: down → up
Enable followspot mode
Enable pan and tilt limits
Set minimum limit for pan angle
Set maximum limit for pan angle
Set minimum limit for tilt angle
Set maximum limit for tilt angle
Optimize pan/tilt movement for speed
Optimize pan/tilt movement for
smoothness
Effects speed follows the speed setting
applied to pan and tilt via DMX or in
control menu
Optimize effects movement for speed
Optimize effects movement for
smoothness
Optically linear dimming curve
Square law dimming curve
Inverse square law dimming curve
S-curve (fixture emulates incandescent
lamp voltage linear RMS dimming curve)
Enable tungsten lamp emulation
Applies alternative color temperature: sets
CLD fixture to warm white and WRM
fixture to cold white by deploying CTC
flags
Focus self-adjusts depending on zoom
angle
Focus remains at distance set via DMX
Color fading optimized for speed of color
changes
Color fading optimized for smoothness
Fixture can be reset via DMX
Fixture cannot be reset via DMX (can be
overridden: see DMX protocol)
27