Press the MENU button up to when the
display. Press the ENTER button and the display will show the
temperature of the unit. To go back to the functions press the MENU
button.
Software version
Press the MENU button up to when the
display. Press the ENTER button and the display will show the version
of software of the unit. To go back to the functions press the MENU
button.
DMX Controller
By using a universal DMX controller to control the units, you will
need to set DMX address from 1 to 512 so that the units can receive
DMX signal.
Press the MENU button up to when the DMX Address is showing on
the display. Pressing the ENTER button and the display will blink. Use
the DOWN/UP button to change the DMX512 address. Once the
address has been selected, press the ENTER button to setup, to go
back to the functions without any change press the MENU button
again. Hold and press the MENU button about one second or wait
for one minute to exit the menu mode.
Please refer to the following diagram to address your DMX512
8B
is blinking on the
is blinking on the