Installation (Electrical) - ProMinent DULCOMARIN II Assembly And Installation Manual

Assembly and installation

5.2.2 Installation (electrical)

For wall mounting
28
6. Tighten the wall/pipe bracket
7. Hook in the housing at the top in the wall/pipe bracket and
push it using light pressure at the bottom against the wall/
pipe bracket. Then press the housing upwards, until it audibly
engages
WARNING!
Safe operating status
During installation the device must not be electrically
live.
The installation must only be carried out by technically
trained personnel.
Observe the technical data in these instructions.
NOTICE!
Cable strain relief
With control panel mounting, the cables must be
routed in a site-provided cable duct to ensure strain
relief.
1. Undo the four housing screws.
2.
NOTICE!
The hinge between the front and rear part of the
housing cannot absorb high mechanical loading.
When working on the front part of the housing
you must support it.
Raise the front part slightly forwards and then fold out to the
left.
A0274