Connect The Coaxial Cable; Connecting The Terminals - ProMinent DULCOMARIN II Assembly And Installation Manual

Assembly and installation

5.1.4 Connect the coaxial cable

The pH or redox sensor is connected
using a coaxial cable

5.1.5 Connecting the terminals

26
Fig. 12: Removing the cable insulation
1. Uncover the cable shielding according to Fig. 12
2. Tightly clamp the shielding
The wiring diagram is contained in the appendix.
Additionally there is an info field on the modules adja‐
cent to the terminals containing connection informa‐
tion.
Fig. 13: Removing the cable insulation
1. Remove the insulation from the fork ends according to
Fig. 13 and press on the corresponding cable end sleeves
2. Pull off the terminal blocks P1 to P4 for installation
3. To fit the cable, push the supplied screwdriver right into the
square opening of the corresponding terminal in order to plug
the cable end into the terminal block
4. Connect the cables according to the wiring diagram
5. Push the pulled-off terminal blocks back onto the circuit
board after connecting the cables
A0496
A0508