Xerox VersaLink C600 User Manual page 155

Symptom
Color around the edge of
printing is incorrect.
Stray black dots or white areas
(dropouts).
• Vertical black or color
streaks or multiple colored
streaks or lines.
• Streaks in only one color.
® ®
Xerox VersaLink C600 Color Printer
User Guide
Probable Causes
The color registration is incor-
rect.
The paper is outside the recom-
mended specification range.
There is debris on the rollers.
The toner cartridges are not
Xerox ® toner cartridges.
The toner cartridges are not
Xerox ® toner cartridges.
Debris in the printer is dragging
against the toner before it is
fused.
There is a problem with the
toner cartridge for that color.
There is debris on the transfer
belt.
Troubleshooting
Solutions
Adjust the color registration.
For details, see details, refer to
Color Registration.
Replace the paper with a recom-
mended size and type, then
confirm that your control panel
and print driver settings are
correct. For details, refer to
Supported Paper.
Wipe the feed rollers with a
clean damp cloth to remove
debris from the rollers.
Note
Do not touch the transfer roller
or the exposed end of the
transfer belt. Fingerprints can
cause print-quality issues.
Ensure that the toner cart-
ridges meet specifications. Re-
place the cartridges if neces-
sary. For details, refer to Con-
sumables.
Ensure that the toner cart-
ridges meet specifications. Re-
place the cartridges if neces-
sary. For details, refer to Con-
sumables.
Remove any debris or paper
scraps from the paper path
under the rear cover.
Check the toner cartridge for
damage, then replace if neces-
sary. For assistance, go to the
®
Xerox Support website at
www.xerox.com/of-
fice/VLC600support.
At the printer control panel,
perform a transfer belt clean-
ing procedure. For details, refer
to Performing a Transfer Belt
Cleaning Mode Procedure.
8-21