HP 330 Service Information Manual page 148

Note
HP 98626 cards are shipped with these switches at zero. When booted
with ENQ/ ACK enabled on the HP 98626 card and XON /XOFF en-
abled on the terrrlinal, the Boot ROM sequence stops, waiting forever
for a response.
Since the HP 98644 and HP 98642 cards do not have line characteristic switches, they will
always be assigned the following characteristics when used as remote console by the Boot ROM:
• 8 bits/char.
• No parity.
• A single stop bit.
• 9600 baud.
• XON /XOFF handshaking.
The terminal's display will be the same as a monitor driven by video electronics on video board.
Keyboard functions will be as driven by the system interface board, except that the
I
Break
I
key
on the terminal is mapped to the
I
Reset
I
key on the local keyboard.
During the self-test of I/O cards, the card driving the remote interface will not be disturbed.
It was tested earlier and passed. Otherwise, the interface could be disabled.
132
Boot ROM Functions