Table of Contents
Advertisement
Introduction
You may configure the NQuire with the web-based tool or by scanning programming barcodes.
Configuring the NQuire with the Web-based Tool
The NQuire has a built-in web server which can be used for device configuration. This configuration
method effectively bypasses the restrictions imposed by operating system. You may access the
configuration tool by following the instructions below.
1. Open a web browser on your PC (IE11 is recommended).
2. Enter the NQuire's default IP address 192.168.1.200 in the address bar and then press Enter to open
the NQuire configuration tool homepage.
If an error page is displayed, please try pinging the NQuire.
i. Make sure your PC is in the same IP range as the NQuire, e.g. 192.168.1.198.
ii. Type "ping 192.168.1.200" in your Command Prompt (MS Windows: cmd.exe) and then press Enter.
iii. If the problem still persists, please double-check the IP address and physical Ethernet connection.
Chapter 3 Configuring the NQuire
Menu
11
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
