Newland NLS-NQuire300 User Manual page 13

Power-over-Ethernet (PoE) solution
Step 1: Put the NQuire face down. Remove the port cover on the right.
Step 2: Connect one end of an Ethernet cable to the Ethernet port on the NQuire.
Step 3: Lead the cable through the cable trough for appropriate routing.
Step 4: Replace the port cover and fasten it with the screw.
Step 5: Connect the other end of the Ethernet cable to a PoE power module or a PoE switch (NOT
supplied by Newland). The NQuire supports both the Mid-span and End-span PoE protocol.
Step 6: Connect DC power to either the third-party PoE power module or PoE switch if required.
Note: Do not connect power adapter to the power jack on the NQuire when adopting PoE solution.
Otherwise there is a risk of damage to the NQuire.
7