Newland NLS-NQuire300 User Manual page 23

Mifare scanner: Besides scanning barcodes, the CIT app that comes preinstalled on the NQuire also
allows users to read from and write to Mifare Classic Mini/1K/2K/4K tags/cards. The following provides
instructions for setting the Mifare scanner parameters.
1. Rfid message prefix: Enter the character(s) (up to 5 characters) you want to add before RFID
message.
2. Access key A: Enter the access key A as hexadecimal characters (no key B can be inserted) which has
been defined for your Mifare tags/cards.
3. Sector to read: Define which sector(s) and block(s) of the Mifare tag/card should be read in the format
of sector:block,sector:block,...sector:block. For example, 14:0,14:1,15:0 means to read blocks 0
and 1 in sector 14 and block 0 in sector 15.
4. Cardnum formatting: Specify whether tag/card number is transmitted as a hexadecimal number or a
binary number.
5. Send card number only: No sectors will be read, just the tag/card number will be sent to the server.
6. Sector data format: Specify whether sector data is transmitted in binary, base64 or hexadecimal
format.
7. Sector data separator: Specify what separator is used to separate the different blocks read.
8. Suppress scan beep: Set whether to turn off the beep when the NQuire reads a tag/card.
9. Access violation/ Incomplete scan/ Write error message: You can change these messages as per your
actual needs.
Note: When you finish making changes to the parameters in a box, do not forget to click "Apply settings" to
save the changes.
17