Setting For Sensor Adapter; How To Set The Equipment Id - Furuno VR-7000 Instruction Manual

7. SETTING FOR SENSOR
ADAPTER
The default Equipment ID of the sensor adapter is "MCV016". Set the individual Equip-
ment ID before connecting to the network.
Connect the Sensor Adapter to the processor unit after setting the equipment ID. Then
enter the other settings of the Sensor Adapter from the Common Installation Setting
menu in the processor unit.
Do "Save and Sync" at the connected FURUNO ECDIS or radar.
7.1

How to Set the Equipment ID

1. Set the IP address and subnet mask of the PC as shown below.
IP address: 172.31.16.201 (or 172.31.16.202)
Subnet mask: 255.255.0.0
2. Connect the laptop PC to the sensor adapter with the LAN cable.
3. Activate the web browser on the PC and enter the default IP address of the sensor
adapter: "172.31.17.108".
4. Access the [Common Installation Setting] menu and click [Basic Setting] on the
tab bar.
5. Select the Equipment ID from the pull-down list. The [Equipment Name], [Equip-
ment Type No.] and [IP Address] are automatically entered according to the
Equipment ID.
Setting range: "MCV001" to "MCV016"
6. Click the box of [Serial No.] to enter the serial no. of the sensor adapter (example:
xxxxxx).
7. Set [Subsystem] to disconnect the sensor network between the units that com-
prise the network.
When disconnecting the sensor network: Set the value. Setting range: "A" to "Z".
Do not disconnect the sensor network: Keep the default setting ("---").
8. After entering the setting, click [Save] on the info bar. The system is rebooted au-
tomatically to save the configuration.
If you want to discard the entry, click [Discard Changes].
7-1