Software Configuration; How To Configure The Vr-7000 With The Vdr Maintenance Viewer - Furuno VR-7000 Instruction Manual

2.

SOFTWARE CONFIGURATION

Disconnect the Remote Alert Panel until the software configuration is completed,
otherwise the audio alarm for no radar video will sound. Also, disconnect the AMS if
applicable.
1. In the Maintenance Viewer, log in to [Serviceman].
2. Download the configuration data from the VDR into the VDR Maintenance Viewer.
3. Set the items in each tab, referring to the descriptions in section 2.2 and after in
this chapter.
4. Save the data to the VDR.
5. Click the [Write] button to backup the data to the DRU (Fixed, Float), Long Term
Device and the CompactFlash.
2.1 How to Configure the VR-7000 with the VDR
Maintenance Viewer
1. Connect the PC and DRU to the DCU.
2. Turn on the VDR and wait approx. four minutes.
3. Download "equip.xml" from the VDR to the PC as follows:
1) Open Internet Explorer
2) Enter the URL ftp://172.31.16.201/pub/ *to access the VDR from the PC.
* IP address may be 172.31.16.202.
3) Copy the file "equipment.xml" to the desktop of the PC.
4. Start the VDR Maintenance Viewer.
5. Enter the IP address 172.31.16.201 (or 172.31.16.202) in the [Maintenance Login]
dialog box.
6. Check [Serviceman], enter the password then click the [OK] button.
Note: Do not release the password to unauthorized personnel.
If the connection is successful, the information shown below appears in the status
area. The Product Name the size of the Fixed DRU and Float are displayed upon
completion of the setting of the file in step 11.
• System Time
• RAP Status
• Power Status
If an error message appears, the IP address or password may be wrong, or the
cable between the PC and the VDR is not correctly connected.
®
on the PC.
• Fixed DRU Information
• Float-free DRU Information
• Long Term Device Information
2-1