Sensor (Lan) - Furuno VR-7000 Instruction Manual

2. SOFTWARE CONFIGURATION
2.18

Sensor (LAN)

The [Sensor (LAN)] tab sets up sensors connected via LAN.
Description of the items in the Information window
[CH No.]: Channel No.
[Type No.]: Type of device.
[SFID]: System Function ID.
[Status]: Status of device, [Active], [Fail], or [None].
[Check]: Results of check, [OK], [NG] (No Good), or [Not Comp] (Not Checked).
Description of the items in the Setting window
[Set] button: Reflect settings to server.
[Capture] button: After setting channels, click this button see if data is received. If not
received, lower baud rate.
[Select Equipment] button: Select equipment settings (saved to the database) to reflect
in channel.
[Reflect Equipment] button: Save the equipment setting data to the database.
[Check] button: Check all channels. The results are shown as [OK] or [NG] (No Good),
in the [Information] window.
[P-sentence] button: Show the [P-sentence definition] dialog box. (See "Description of
the buttons in the Setting window" on page 2-8 for usage.)
[Active]: Check to make device active.
[Brand]: Enter the brand name of device.
[Type No]: Type of device; for example, GPS.
[System Function ID]: Enter SFID (System Function ID); for example, GP0001. (Do not
set multiple SFIDs.)
[Check]: Show check results. Same as [Check] in the [Information] window.
[Data Name]: Input name of data.
[Data Type]: Set data type, [NMEA], [ASCII], or [Binary].
[Source Checksum]: Notify or do not notify if GPS data is missing checksum. If un-
checked, sentence error is not notified when there is no checksum.
[Time Out]: Set the timeout. The choices are [5 s], [10 s], [20 s], [30 s], [60 s], [120 s],
[180 s], and [No-Timeout].
[Equipment Category]: Enter the equipment category.
[Note]: Enter remarks. (Entry optional.)
2-30