How To Set Ip Addresses In The Sample Programs - Rabbit RabbitCore RCM3209 User Manual

6.4.1 How to Set IP Addresses in the Sample Programs

With the introduction of Dynamic C 7.30 we have taken steps to make it easier to run
many of our sample programs. Instead of the
see a macro. This macro tells Dynamic C to select your configuration from a
TCPCONFIG
list of default configurations. You will have three choices when you encounter a sample
program with the
TCPCONFIG
1. You can replace the
,
MY_NETMASK MY_GATEWAY
2. You can leave
TCPCONFIG
to , the netmask to
10.10.6.100
to . If you would like to change the default values, for example, to use an IP
10.10.6.1
address of
10.1.1.2
the values in the section that directly follows the "General Configuration" comment in
the
TCP_CONFIG.LIB
3. You can create a
CUSTOM_CONFIG.LIB
than 100. Instructions for doing this are at the beginning of the
There are some other "standard" configurations for
ent features such as DHCP. Their values are documented at the top of the
library. More information is available in the Dynamic C TCP/IP
TCP_CONFIG.LIB
User's Manual.
48
macro.
macro with individual
TCPCONFIG
, and
MY_NAMESERVER
at the usual default of 1, which will set the IP configurations
255.255.255.0
for the RCM3209 board, and
library. You will find this library in the
and other macros, you will
MY_IP_ADDRESS
MY_IP_ADDRESS
macros in each program.
, and the nameserver and gateway
10.1.1.1
library and use a
TCPCONFIG
TCPCONFIG
RabbitCore RCM3209/RCM3229
,
for your PC, you can edit
directory.
LIB/TCPIP
value greater
TCP_CONFIG.LIB
that let you select differ-
file.