Advertisement
e) Check video output format to LED monitor or HD monitor is
compatible with TX and RX;
2) Poor output video quality
a) Check if HDMI input or output cable is plugged well or not;
b) Then checks how many receiver side 'RSSI' LEDs are lit, there should
be 2-3 RSSI LEDs lit if the user want to get better video quality; if there is
only 1 RSSI LED lit, that means the received wireless signal is weak, and
should replace the TX or RX's antennas;
c) If the video quality no improvement, and there is only 1 RSSI LED lit,
then change both TX and RX's wireless communication frequency point
or should shorten the connection distance,and adjust the antenna's
director as per the user manual mentioned;
3) Display terminal has been on "searching":
e) Check TX is powered on, and check HDMI cable is plugged well or not;
f) Ensure TX and RX's frequency point is the same ;
g) Ensure TX and RX's location should not be less than 1.5m from the
ground;
h) If the image no improvement, change the TX and RX's wireless
communication frequency point or should shorten the wireless
connection distance,and adjust the antenna's direction;
4) Display terminal has been on "XX is connected,please check the video
source...."
19
Advertisement
