Operating Frequency - Fcc And Ic - Bartec Agile X IS User Manual

Industry Tablet PC 10.1"
Type 17-A1B*-****/********
7.4

Operating frequency - FCC and IC

Only 5 GHz
Industry Canada Statement
FCC-Anforderungen zum
Schutz vor Hochfrequenz-
störungen
Declaration in accordance
with the FCC regulations,
Part 15.21
Subject to technical changes.
05/2017
Agile X IS
The use in the UNII (Unlicensed National Information Infrastructure) band 1 5150 -5250
MHz band is restricted to Indoor Use Only; any other use will make the operation of this
device illegal.
CAUTION - AVERTISSEMENT
Devices can be damaged by inappropriate handling!
The device for operation in the band 5150-5250 MHz is only for indoor use to

reduce the potential for harmful interference to co-channel mobile satellite systems;
High-power radars are allocated as primary users (i.e. priority users) of the bands

5250-5350 MHz and 5650-5850 MHz and that these radars could cause
interference and/or damage to LE-LAN devices.
Devices can be damaged by inappropriate handling!
Les dispositifs fonctionnant dans la bande 5 150-5 250 MHz sont réservés

uniquement pour une utilisation à l'intérieur afin de réduire les risques de brouillage
préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux;
De plus, les utilisateurs devraient aussi être avisés que les utilisateurs de radars de

haute puissance sont désignés utilisateurs principaux (c.-à-d., qu'ils ont la priorité)
pour les bandes 5 250-5 350 MHz et 5 650-5 850 MHz et que ces radars pourraient
causer du brouillage et/ou des dommages aux dispositifs LAN-EL.
against disturbances if the device is used in residential areas.
The device generates and uses radio frequency energy and may emit this energy. This
can have a disturbing effect on other radio frequencies if the device is not connected
and used in accordance with the operating instructions. A guarantee that no
interference will arise for a certain installation cannot be given.
If the device causes interference to the radio or TV reception which can be recognized
by switching the device on and off, the interference should be eliminated by one or
several of the following measures:
Re-alignment or moving of the receiving aerial.
−
Enlarging the distance between device and receiver.
−
Connecting the device to a different socket than the one to which the receiver is
−
connected.
Advice from the dealer or a radio/television technician.
−
Changes which have not been explicitly approved by the party responsible for
compliance with the regulations can lead to the expiry of the operating authorization for
this device.
This device has been tested and satisfies the limit
values for a digital device of Class B according to
Part 15 of the FCC Guideline. These limit values
were stipulated to guarantee appropriate protection
Operation
EN 33/43