Table of Contents
Advertisement
Before unlocking
›
Move the outer seat backwards as far as it will go and fold up
›
On the centre seat, remove the headrest and fold up the seat
Unlock and remove
›
Unlock the seat by pressing the seat locks
» Fig.
86.
›
Remove the seat on the carrying handle
›
When the middle seat has been removed, close the cover for the socket in
the floor in the direction of arrow
CAUTION
The outer seat must be at the back of the unit before it is folded up - there is
■
a risk of damage to the locking mechanism when the seat is unlocked and re-
moved.
The socket in the floor must be protected with the cover after removing the
■
middle seat - there is the risk of damage to the socket.
Note
The outer seats are not mutually interchangeable. The left seat in the rear area
is marked with the letter L and the right seat with the letter R.
Adjusting seats in crosswise direction
›
Remove the middle seat and close the cover for the socket in the floor
» Fig. 86
on page 86.
›
Fold the outer seat up and unlock.
›
Move seat on the guide rods towards the middle of the vehicle up to the
stop.
›
Lock the seat at the end of the guide rods by pressing the seat locks
the direction of arrow
» Fig.
87.
»
.
» page
in direction of arrow
A
or
.
B
C
.
2
Fig. 87
Locking seats
Folding back into the starting position is accomplished in the reverse order.
86.
Folding back seats
1
›
If the seat has been removed, first position it on the guide rods and lock it in
place with the seat locks
ensure that the seat is locked correctly.
›
Before inserting the middle seat, open the cap for the socket in the ground
opposite the direction of the arrow
›
Fold the seat in the horizontal position until it audibly click in place. Check
that the seat can no longer be lifted by pulling it up.
›
Pull on the loop in the direction of arrow
backrest in direction of arrow
WARNING
The seat backrests in the occupied rear seats must be properly engaged.
CAUTION
Be sure to check the plugs on the bottom of the seats and the plugs under
■
the seats for soiling before inserting or folding the seats forwards - there is a
risk of functions being restricted
Before tilting the centre seat forwards, the cover for the socket in the floor
■
must be opened - there is a risk of damage to the plug on the underside of the
seat.
Plugs and sockets under the seats
On vehicles with seat belt heating or seat heating, there are plugs on the un-
derside of the seats and sockets under the seats.
in
A
Fig. 88
Folding the seat backrest back
into position
» Fig. 87
on page 87. Pull the seat upwards to
A
» Fig. 86
on page 86.
2
1
» Fig. 88
and fold back the seat
. Check this by pulling on the seat backrest.
2
» page
87.
Seats and head restraints
87
Advertisement
Table of Contents
