Table of Contents
Advertisement
›
After charging has been successful: Switch off the charger and remove the
mains cable from the power socket.
›
Disconnect the terminals of the charger from the vehicle battery.
A charging current of 0.1 multiple of the total vehicle battery capacity (or low-
er) must be used until full charging is achieved.
WARNING
When charging the vehicle battery, hydrogen is released - risk of explo-
■
sion. An explosion can be caused from sparks or connection or releasing
the cable plug while the ignition is on.
The so-called "quick charging" of the vehicle battery is dangerous and re-
■
quires a special charger and specialist knowledge. Therefore, have "Quick
loading" carried out by a specialist garage.
Disconnect/reconnect and change
Read and observe
and
The new vehicle battery must have the same capacity, voltage, current and the
same size as the original Battery.
We recommend you have the battery replaced by a specialist garage.
›
To disconnect the battery, switch off the ignition and disconnect first the
negative terminal , and only after this the positive .
›
To connect the battery, first connect the positive terminal , and only after
this the negative terminal .
After disconnecting and re-connecting the vehicle battery, the following func-
tions or devices are partially or completely inoperative.
Function / device
Power windows
Panorama sliding/tilting roof
Sun screen
Time setting
on page 265 first.
Operating measure
» page 66
» page 68
» page 68
» page 49
CAUTION
Disconnect the vehicle battery only with the ignition turned off - there is a
■
risk of damaging the electrical system of the vehicle.
Before disconnecting the battery, close the electric tailgate, all the windows,
■
the sliding / tilting roof and the electric sunshade - otherwise malfunctions of
equipment elements may occur.
Under no circumstances must the connection cables be connected incor-
■
rectly – risk of fire.
Note
After disconnecting and re-connecting the vehicle battery, we recommend
having the vehicle checked by a specialist to ensure that the full functionality
of all electrical systems is guaranteed.
267
Inspecting and replenishing
Advertisement
Table of Contents
