Table of Contents
Advertisement
Note
If the inclination angle of the seat backrest relative to the seat surface is
■
greater than approx. 110°, then it is not possible for safety reasons to save this
setting in the memory of the electrically adjustable seats or the remote control
key.
On vehicles with personalisation, the driver's seat setting is stored in the ac-
■
tive user account personalisation
Memory Function of the electrically adjustable seat
Read and observe
on page 81 first.
Among the memory buttons
B
seat and exterior mirror position can be saved
Storing driver's seat and exterior mirror settings for the forwards drive
›
Switch on the ignition, adjust the seat and the exterior mirrors, as required.
›
Press the
» Fig. 76
button and then, within 10 seconds, press the de-
A
sired memory button
. Storing is confirmed by an acoustic signal.
B
Storing front passenger´s exterior mirror settings for reversing
The function for lowering the front passenger's mirror area during reversing
can be activated in Infotainment in the menu
›
Turn on the ignition and press the desired memory button
›
Turn the rotary knob for the exterior mirror control to the position for the
front passenger mirror area
» page
›
Engage reverse gear.
›
Adjust the front passenger's mirror to the desired position.
›
Disengage reverse gear. The set position of the exterior mirror is stored.
82
Operation
» page
55.
Fig. 76
SET button and memory but-
tons
on the driver's seat, a setting for the driver´s
» Fig.
76.
/ → → Mirrors and wipers.
» Fig.
B
79.
Retrieving the saved setting
›
With the ignition off and open driver's door, press the desired memory but-
ton
.
B
›
In other cases (e.g. if the ignition is switched on or the driver's door closed),
hold the button.
Stopping the ongoing adjustment
›
Press any button on the driver's seat or the button on the remote control
key.
Note
Every time you save new seat and exterior mirror settings for driving forwards,
you must also save the front passenger mirror setting for reversing again.
Memory function of the remote control key
Applies to vehicles that do not have the personalisation function.
Read and observe
Every time the vehicle is locked, the driver´s seat and exterior mirror settings
are saved and assigned to the key with which the vehicle was locked.
After the following unlocking of the vehicle with the same key and opening the
driver's door, the driver´s seat and exterior mirrors that are saved to this key
will be adopted.
This function can be used in Infotainment in the menu
tivated/deactivated).
Storing front passenger´s exterior mirror settings for reversing
The function for lowering the front passenger's mirror area during reversing
can be activated in Infotainment in the menu
›
Unlock the vehicle with the remote control key and switch on the ignition.
›
Turn the rotary knob for the exterior mirror control to the position for the
76.
front passenger mirror area
›
Engage reverse gear.
›
Adjust the front passenger's mirror to the desired position.
›
Disengage reverse gear. The adjusted position of the exterior mirror is stored
in the remote control key memory.
on page 81 first.
/ → → Seats (ac-
/ → → Mirrors and wipers.
» page
79.
Advertisement
Table of Contents
