Table of Contents
Advertisement
Gesture control
Only valid for Infotainment Columbus.
Some menus of Infotainment Columbus can be operated by means of hand
gestures by slowly moving the hand back and forth approximately 8 cm above
the Infotainment screen.
The menus with gesture control feature the symbol in the lower right-hand
corner
» Fig.
167.
Switching the function on / off
The gesture control function is switched on at the factory.
›
To switch the function on/off, tap the sensor field
tion surface → Screen → Hand gesture.
Acoustic confirmation of gesture
When the function is switched on, Infotainment indicates that a gesture has
been recognised by means of an acoustic signal.
›
To activate/deactivate the acoustic confirmation of a recognised gesture,
tap the sensor field
and then the function surface → Screen → Audible
hand gesture feedback.
Visual confirmation of the gesture
When the function is switched on and a gesture has been recognised, Infotain-
ment shows an animation with the bottom bar moving in the direction of the
hand movement.
›
To activate/deactivate the visual confirmation of a recognised gesture, tap
the sensor field
and then the function surface → Screen → Visual hand
gesture feedback.
Only valid for Infotainment Columbus.
›
›
Fig. 167
Example of a menu with
Applies to Infotainment Amundsen, Bolero, Swing
gesture control
›
Automatic switch-on of Infotainment
If Infotainment was not turned off with
it will automatically switch on when the ignition is switched on.
Automatic switch-off of Infotainment
If the vehicle key is pulled out of the ignition lock while Infotainment is switch-
ed on, Infotainment will switch off automatically.
If the vehicle is fitted with the starter button, Infotainment will switch off au-
tomatically after the engine is switched off and the door is opened.
With the ignition off, Infotainment will automatically turn off after about 30
minutes.
Infotainment turns off automatically under certain circumstances. Infotain-
ment informs of this via a text message on the Infotainment display.
and then the func-
Restart of Infotainment
If Infotainment does not respond (if it "freezes") This can be restarted by hold-
ing
Standby mode
With the ignition off and infotainment (standbyMode), it is possible to display
the time and date in the Infotainment screen.
Applies to Infotainment Columbus, Amundsen, Bolero
▶
Applies to Infotainment Swing
▶
The display mode can be changed by moving your finger sideways across the
screen (does not apply to Infotainment Swing).
Restart Infotainment Switching Infotainment on / off
To switch on Infotainment, press
To switch off Infotainment, hold
To switch on/off Infotainment, press
for longer than 10 s.
Show time and date on the screen
To switch the time and date display on/off, press the
then tap the function surface → Screen → Show clock in standby mode.
To activate / deactivate the time and date display button
function surface screen → Show clock in standby mode Tap.
.
.
.
before the ignition was turned off,
sensor field and
press, then the
Infotainment operation
125
Advertisement
Table of Contents
