Do not polish the paintwork in a dusty environment - risk of paint scratch-
■
es.
Do not apply any paint care products to door seals or window guides.
■
Plastic parts
■
Do not use paint care products.
■
Chromed and anodised parts
■
Do not polish the chrome parts in a dusty environment - risk of surface
■
scratches.
Foils
■
The following instructions must be observed, otherwise there is a risk of foil
damage.
Do not clean with dirty cloths or sponges.
■
To remove ice and snow, do not use a scraper or other means.
■
Do not polish the foils
■
Do not use a pressure washer to clean the foils
■
Rubber seals
■
Do not treat the door seals and window guides with any products - the pro-
■
tective lacquer layer could be affected.
Windows and external mirror glass
■
Do not clean the inside of the windows with sharp objects - there is a risk
■
of damage to the filaments or glass antenna.
Do not use a cloth, which was used to polish the body - this could soil the
■
window and reduce visibility.
Headlights/lights
■
Do not dry off the headlights/lights, do not use sharp objects - there is a
■
risk of damage to the protective coating and subsequent cracking of the
headlight glass.
Reversing camera
■
The following instructions must be observed, otherwise there is a risk of
camera damage.
Do not remove snow / ice with warm / hot water.
■
To wash, never use a pressure washer or steam jet.
■
For cleaning, do not use abrasive cleaners.
■
Door lock cylinder
■
Make sure that as little water as possible gets into the locking cylinder
■
when washing the vehicle - there is a risk of freezing the lock cylinder!
Wheels
■
Heavy contamination of the wheels can affect the balance of the wheels -
■
this can result in vibrations and, under some circumstances, can cause pre-
mature wear of the steering wheel.
Removing snow and ice from the windscreens
Read and observe
and
Use a plastic ice scraper for removing snow and ice from the windows and
mirrors. This can be on the inside of the fuel filler flap.
›
Open the fuel filler flap and slide the scraper in the direction of arrow
» Fig.
291.
CAUTION
Move the scraper in one direction only, otherwise there is a risk of damage to
■
the glass surface.
Do not remove snow / ice on the surface that is soiled (e.g. pea gravel, sand,
■
road salt) - there is a risk of damaging the surface.
Remove snow / ice carefully, otherwise there is a risk of damaging the labels
■
that have been fitted by the factory.
Fig. 291
Installation location of the ice
scraper, removing the scraper
on page 253 first.
Care and maintenance
255