Pole Mounted Installations - Motorola AP-7161 Installation Manual

AP-7161 Access Point Installation Guide

Pole Mounted Installations

The mounting bracket kit and extension can be used in various combinations to properly install the AP-7161 on a pole. For poles
of up to 3 inches in diameter, attach SKJC120210-003 at the desired position on the pole using a 1/2 inch U-bolt and nuts (not
included in the mounting bracket kit).
CAUTION
For poles up to 3 inches in diameter:
Thread the two outer nuts onto the U-bolt. Place the U-bolt at the desired mounting location.
1.
Place the SKJC120210-003 bracket section on the U bolt. Adjust the nuts until the bracket section is against the pole and the
2.
U-bolt can be secured tightly to the pole by.
Put the two inner nuts on the U-bolt to securely attach the mounting bracket section. Adjust the nuts until the U-bolt and the
3.
bracket section are securely attached to the pole
Tighten the nuts to 70 inch pounds (lbf-in).
4.
Using a torque wrench or a ratchet and a 10mm socket, attach (but don't tighten) SKJC120210-001 to the access point with
5.
four M6 hex flange screws.
Using a torque wrench or a ratchet and a 10mm socket, attach (but don't tighten) SKJC120210-001 to SKJC120210-001 with
6.
four M6 hex flange screws.
To adjust the position of the access point, rotate SKJC120210-001 (plus or minus 15 degrees) and tilt SKJC120210-002 (up
7.
to 45 degrees).
Always mount the AP-7161 with the black gore vent facing down.
17