Motorola AP-7161 Installation Manual page 19

AP-7161 Access Point Installation Guide
Using a torque wrench or a ratchet and a 10mm socket, attach (but don't tighten) SKJC120210-001 to SKJC120210-001 with
4.
four M6 hex flange screws.
To adjust the position of the access point, rotate SKJC120210-001 (plus or minus 15 degrees) and tilt SKJC120210-002 (up
5.
to 45 degrees).
Tighten all hex flange screws to 9 inch pounds (lbf-in).
6.
Examples for using the extension bracket alone, or with the mounting bracket for a pole mount installation are shown below.
To use the extension bracket:
Using a torque wrench or a ratchet and a 10mm socket, attach the extension bracket to the access point with four M6 hex
1•
flange screws. Tighten the hex flange screws to 9 inch pounds (lbf-in).
Attach the extension bracket to SKJC120210-001 of the assembled mounting bracket using two 1/2 inch bolts and nuts.
2.
Tighten the nuts to 70 inch pounds (lbf-in).
19