Pole Mounted Installations - Motorola AP-8163 Installation Manual

20
The following ancillary hardware to attach the extension arm to the mounting bracket kit sections is included in
the extension arm kit:
Description
1/2 inch hex head nut
1/2 inch x 3/4 inch hex head bolt

2.2 Pole Mounted Installations

The mounting hardware kit and extension arm can be used in various combinations to properly install the AP-8163
on a pole. For poles of up to 3 inches in diameter, attach the pole mount bracket of the mounting hardware kit at
the desired position on the pole using band clamps up to 3/4 inch width, or a 1/2 inch x 4 inch wide U-bolt and
nuts. For poles greater than 3 inches in diameter, attach the pole mount bracket using band clamps.
CAUTION
NOTE
NOTE
Quantity
2
2
Always mount the AP-8163 with the black gore vent facing down.
The U-bolt and band clamps are not included in the mounting bracket kit.
Use of the extension arm is recommended for installations on poles greater than 3
inches in diameter.
AP-8163 Access Point