Motorola AP-7161 Installation Manual page 21

AP-7161 Access Point Installation Guide
To adjust the position of the access point, rotate SKJC120210-001 (plus or minus 15 degrees) and tilt SKJC120210-002 (up
4.
to 45 degrees).
Tighten all hex flange screws to 9 inch pounds (lbf-in).
5.
Examples of options for using the extension bracket alone or with the mounting bracket for a wall mount installation are shown
below.hex
To use only the extension bracket:
Using four #10/32 lag bolts, attach SKJC120210-002 at the desired mounting location.
1•
Using a torque wrench or a ratchet and a 10mm socket, attach the extension bracket to the access point with four M6 hex
2.
flange screws. Tighten the hex flange screws to 9 inch pounds (lbf-in).
To use the extension bracket with the mounting bracket:
Using a torque wrench or a ratchet and a 10mm socket, attach the extension bracket to the access point with four M6 hex
1•
flange screws. Tighten the hex flange screws to 9 inch pounds (lbf-in).
Attach the extension bracket to SKJC120210-001of the assembled mounting bracket already in position using two 1/2 inch
2.
bolts and nuts. Tighten the nuts to 70 inch pounds (lbf-in).
21