Sample Application - Omron CP1H-X40D Operation Manual

Sample Application

9-12 Sample Application
CX-Programmer/CX-Integrator
Node number: 1
IP address: 192.168.250.1
Ethernet port
Ethernet (Network address: None)
FINS/UDP method
586
The following examples show how to connect online from a CX-Programmer
on an Ethernet network to a PLC on the Ethernet network.
Note Please use CX-Programmer version 8.1 or higher (CX-ONE version 3.1 or
higher).
■
System Configuration Example 1: No Routing
In this example, an online connection is made by FINS/UDP to a PLC on an
Ethernet network (PLC1 in the diagram below) from a CX-Programmer / CX-
Integrator connected to the Ethernet network.
Ethernet Option Board
Web Browser Setting
Item
Broadcast
FINS/UDP port
IP address
Subnet mask
FINS Node Address
IP address conversion
Baud rate
IP router tabel
IP address conversion: Automatic generation
method (dynamic)
Ethernet Option Board node number: 2
Ethernet Option Board IP address: 192.168.250.2
COMMERR
10BASE-T
100BASE-TX
Target: PLC1
All ones (4.3BSD)
Default (9600)
192.168.250.2
255.255.255.0
2
Automatic generation method (dynamic)
Automatic Detaction
None
Section 9-12
Setting